Werbung
Verfügbare Sprachen
Verfügbare Sprachen
27.PROGRAM
- Press the PROG button to enter in the program mode
28. IN
This button sets the beginning of the loop. The Loop indicator on the display flashes.
29. OUT
When you press this button, you set the end point of the seamless loop and you start the loop. To
finish the loop, press again this button.
30. RELOOP
This button is used to start the last saved loop. To finish the loop, press the reloop button.
31. 1-4 AND +5 DIGITS
Numerical keys for direct selection of a title.
32. MEMORY
Memory of radio
33. FM/ST
Press this button to change audio between mono stereo and stereo.
34.FM/AM
Press this button to choose the radio modes.FM or AM band.
At first,place the batteries into the remote
control.
Open the batterycompartment.
Insert the batteries AAA(UM-4),made sure
to match+ and - of the batteries to the marks in
the battery compartment.
Close the battery cover.
NOTE:Improper use of the batteries may
cause battey leakage and corrosion. To
operate the remote control correctly,
follow the instructions below:
Do not insert batteries into the remote control in
the wrong direction.
Do not charge,heat,open or short -circuit
batteries.Do not throw batteries into a fire.
●
Do not leave dead or exhausted batteries
in the remote control.
●
Do not use different types of batteries
together or mix old and new batteries.
●
If you do not use the remote control for a
long period of time,remove the batteries to
avoid possible damage from battry
corrosion.
● If the remote control does not function
correctly or the operating range becomes
reduced,replace all batteries with new one.
● If battery leakage occurs,wipe the battery
liquid from the battery compartment,then
insert new batteries.
The batteries can be used for one year in
normal condition.
10
Werbung
