Ism Radio Receiver - dB Technologies Ready 4 Bedienungsanleitung

ENGLISH

ISM radio receiver

This menu enables reception by the ISM radio module
To use this function you need to purchase a HT-READY 4 hand-held transmitter or BT-READY 4 pocket (belt)
transmitter. You need to synchronise the reception/transmission channel, following the procedure
described herein:
1. Switch on the READY 4 MK2 device, then from the main menu select and confirm the icon giving
access to the WIRELESS configuration page.
2. Once inside the page, check that the wireless function of READY 4 MK2 is enabled, with the
relevant icon highlighted
3. The READY 4 MK2 configuration page shall now display the "device not connected" screen:
4. Switch on the HT-READY 4 hand-held transmitter or the BT-READY 4 pocket transmitter. For the
HT-READY 4 hand-held transmitter you need to remove the cover by pressing the relevant
release button and to fully withdraw it, as shown in the figure below.
5. Set the desired reception channel by selecting the relevant icons among the different channels.
6. The IR synchronisation LED, shown below, located in the upper section of the READY 4 MK2
control panel, will use infra-red communication to synchronise the selected channel.
37
.