Operation; Cleaning, Care And Maintenance - AEG DB 70 Bedienungsanleitung

20

opeRAtIoN

As soon as the vehicle plug [4] is connected with the 12 V vehicle socket and is
conducting an electrical charge, the red leD will illuminate. Now the double plug
socket is ready for use and devices can be connected to both 12 V vehicle sockets,
as well as to the USB connection socket.
Note that with some vehicles, the 12 V vehicle socket may only function when the
ignition is switched on.
Use the double plug socket for a short time only if the vehicle engine is not switched
on. Failure to ob-serve this can cause the vehicle battery to run down.
After use, always remove the plug from the 12 V vehicle socket. When removing the
connection, pull on the plug itself, and never on the connecting cable.
cleANING, cARe AND MAINte-
NANce
Fuse
the device is protected with a fuse in the vehicle plug. It is designed to break
the circuit in the event of a short circuit or voltage peaks and must be replaced
afterwards.
4
3
2
1
Warning! Do not install a more powerful fuse. this could cause damage to
the electronic system.
1. Unscrew the retainer ring (1) with the fuse cover (2) from the vehicle plug (4).
2. Insert a new fine wire fuse (3) of the same size (see technical Specifications).
3. Screw the retainer ring (1) with the fuse cover (2) back onto the vehicle plug (4).