Overview; Setup; Installation; Sound-Control - EuroLite LCD-4 MP/S Bedienungsanleitung

4.2 Overview

Overview on the control elements
1) POWER SWITCH
2) KANAL-LEDs
3) CHANNEL FADERS
4) FLASH-BUTTONS
5) MODE LEDs
6) MODE SELECT-BUTTON
7) PROG SELECT-BUTTON
8) DISPLAY
9) FADE TIME-FADER
10) DIMMER
11) AUDIO-FADER
12) SPEED-FADER
13) STANDBY-BUTTON
14) FULL ON-BUTTON
15) TAP SYNC-BUTTON

5. SETUP

5.1 Installation

Install the device on a plane surface or install it in rack.
Rack-installation: This device is built for 19" racks (483 mm). The rack you use should be a Double-Door-
Rack where you can open the frontpanel and the rear panel. The rack should be provided with a cooling fan.
When mounting the controller into the rack, please make sure that there is enough space around the device
so that the heated air can be passed on. Steady overheating will damage your device.
You can fix the controller with four screws M6 in the rack.

5.2 Sound-control

The sound-control works via the built-in microphone or via the sound input socket.
Connect the sound-signal from the mixer (e.g. Master 2) with the RCA-socket on the rear panel (input
sensitivity 0.1 V - 1 V).
13/28 70062666X87NXS_V_1_0.DOC