Connecting The Loudspeakers - Audio Physic AVANTI Bedienungsanleitung

Connecting the AVANTI Loudspeakers
Your new loudspeakers are fitted with particularly high-quality
connectors from the "nextgen" range made by the specialist manufacturer WBT (see the image on the right).
These connectors feature a unique mechanism (the torque indicator) that helps you to connect cables with
spades as explained under point 2. The connectors of the MIDEX loudspeakers accept both spades and banana
plugs. Loose cable strands oxidise easily and are not suitable for a permanently high-quality listening experience.
1. Please switch off all equipment in your Hifi system before you begin to connect your loudspeakers.
2. If you are using a loudspeaker cable with spade connectors, turn the screw clamps to
the left until you can easily slide the spades into the openings at the side. Push the
spades into these openings and turn the screw clamps to the right until you hear a
clicking noise - this is the torque indicator. Now turn the clamps until they are hand-
tight, which will normally be the case after a few more 'clicks'.
After this point, you can indeed tighten the clamps even more, but this will not
improve the results. In the worst case scenario, further tightening
the clamps may lead to damage to the surface structure of the
spade connectors.
3.
Make sure you have the right polarity. As a rule, loudspeaker cables are accordingly labelled, either by a
permanent marking on one of the two conductors of the cable or by plus "+" and minus "-" markings on the
cable ends.
4.
Now connect the cable to your amplifier and make sure that you have the right polarity here.
15