Unpacking And Assembly Of Avanti - Audio Physic AVANTI Bedienungsanleitung

Unpacking and Assembly of AVANTI

1.
Place the boxes on the floor, making sure that the product labels are facing up, and carefully open the
packaging on the long side where it has been taped up, preferably using a pocket knife or kitchen knife (similar
to illustrations).
Wrong
If the loudspeaker upper side
is on top, it is necessary for
you to first turn the loudspeaker
around after removing it from
the packaging, in order to attach
the spikes to the traverses.
2
. Remove the "Welcome to the Audio Physic" package and the accessories.
3.
Carefully remove the loudspeaker together with its protective foam pads, from the upright box. . It is ideal if
two people carry out this step. Make sure that you do not touch the drivers when removing and handling the
loudspeaker as this may cause irreparable damage to the drivers.
4.
Now remove the top foam cover and carefully slide down the protective foil.
5.
In a next step, detach the loudspeaker from the protective foam cover at the bottom and place it carefully on
the floor. It is ideal if two people carry out this step.
6.
In order to attach the spikes to the traverses, one person should slightly tilt the loudspeaker sideways enabling
a second person to easiliy screw the spikes into the designated inserts. Pepeat the process on the opposite
side.
7.
Screw thw caps with the integrated counter nuts onto the spikes.
8. Place the loudspeakers in their intended positions. Make sure that you do not hurt
yourself on the tips of the spikes. Finely adjust the spikes so that the loudspeakers do
not wobble. If you do not place the loudspeakers in a secure and stable position and
they therefore wobble, this will have a major effect on the sound. When the boxes are
standing level and upright, you have set them up perfectly. The enclosed spirit level
will help you to finely adjust the loudspeakers (they are level when the bubble remains
in the inner circle). Now use the lock nuts to again tighten the spikes. Roughly hand-
tightening the nuts is sufficient.
9.
From the factory, the AVANTI loudspeakers are equipped with a solid glass front panel. matching fabric panel
are assembled. Sonically, no loss of the use of fabric covers are to be feared.
If you want to increase the sound quality even more in terms of precision and bass
response, try out our high-quality VC feet (for example VCF II MagneticI M8) in the image
on the right) on your loudspeakers. The "Vibration Control" feet are not only an
alternative to spikes for high-quality flooring, but also reduce the transmission of
vibrations between the loudspeakers and the floor. The result is an audible improvement
in the lefel of detail and realistic sound reproduction.
Right
The loudspeaker upper side
should be on the bottom during
unpacking. If you now carefully
pull the loudspeaker out of the
packaging, you can grip the
loudspeaker on its underside
with the traverses and can easily
attach the spikes.
14