Espressione Unico Splendor Gebrauch Und Instandhaltung Seite 7

setting up
-
take off the steel cop holder
-
remove the water reservoire
-
clean and fill up the water reservoire
-
reposition the water reservoire and insert the silicon tubes
-
close the cups heater/holder
-
plug the machine in
-
turn on the machine in positioning the switch (nr 4) in position (on),
-
the pilot light will turn on
-
push up the coffee lever and the boiler will fill in automatically
-
wait around 3-4 minutes so that the machine can go in pression, look
at the pression manometer (the needle has to be placed between 1,1
and 1,4 bar) the coffee pilot light will turn off (green)
-
just at this point the machine is ready to use
in case that the water should finish or miss, one micro, placed under the
plate of the coin keeper, will operate and will turn off the machine.
you have to do following steps to be able to use another time the machine
- turn off the machine with the main switcher putting it on position (o)
- plug off the cave
- fill in the water boiler with water
- replug in the machine
- turn on the machine in positioning the main switch in position (on),
the pilot light will turn on
- push up the coffee lever and wait until water runs out from the
lower part of the erogation group
- push down the coffee lever and the boiler will fill in automatically
- wait around 3-4 minutes so that the machine can go in pression, look
at the pression manometer (the needle has to be placed between 1,1
and 1,4 bar), the coffee light pilot (green) will turn off
7