Changing The Operating Parameters For A Measuring Point; Operating Mode Suction/Oppressive - Sl Analytics AVS 370 Gebrauchsanleitung

55
Fig. 6 Hardware management: Device information and operating parameters

4.5.2 Changing the operating parameters for a measuring point

The operating parameters are selected in the right half of the "Hardware" tab. Please keep in mind that
the settings you select refer to the measuring point (1, 2 ...) listed under "Device-Information".
The measuring point for the respective device is selected by clicking on respective device below the
device information in the list.
Changing the operating parameters is only possible with those measuring points where no
measurement is active.

4.5.3 Operating mode suction/oppressive

The desired operating mode ("Operationmode") is selected by switching between "sucking" and
"pressing". The operating mode "sucking" is preset.
The hose set for the pneumatic connections between the ViscoPump II and the Viscometer
must match the respective operating mode! If the connection is not correct, the measurements
will not work, and there is the additional risk that the sample will exit from the viscometer or
will be suctioned into the ViscoPump II!