Axis M32-Series Installationsanleitung Seite 9

AXIS M32 Series Installation Guide
AXIS Camera Management - multiple cameras/large installations
AXIS Camera Management can automatically discover multiple Axis devices, show connection
status, manage firmware upgrades and set IP addresses.
Automatic discovery
1. Check that the camera is connected to the network and that power has been applied.
2. Start AXIS Camera Management. When the AXIS M32 Series network camera appears in the
window, double-click it to open the camera's home page.
3. See page 10 for instructions on how to set the password.
Assign an IP address in a single device
1. Select the AXIS M32 Series network camera in AXIS Camera
Management and click the Assign IP button.
2. Select Assign the following IP address and enter the IP
address, subnet mask and default router the device will use.
3. Click the OK button.
Assign IP addresses in multiple devices
AXIS Camera Management speeds up the process of assigning IP
addresses to multiple devices, by suggesting IP addresses from a
specified range.
1. Select the devices you wish to configure (different models can
be selected) and click the Assign IP button.
2. Select Assign the following IP address range and enter the
range of IP addresses, the subnet mask and default router the
devices will use.
3. Click the OK button.
Note:
AXIS M3203-V and AXIS M3204-V will display in AXIS Camera Management as AXIS
M3203 and AXIS M3204.
Page 9