Electrical Connection; Manual Manoeuvres; Testing; Maintenance - Mhouse KS2 Anweisungen Und Hinweise Für Den Installateur

4) Electrical connection

Use the contacts available for your equipment control. Never try to
command the motor directly. Fig. 10
10

5) Manual manoeuvres

To release the gearmotor proceed as follows:
1. Manual operation must be performed when the gate is closed.
2. Turn the key completely using the finger to guide the release
handle; Fig. 11
3. Open the release handle 90° Fig. 12. In this case there should
be sufficient cable run to release the RG automatism. However,
if the automatism requires a longer run, proceed as follows;
4. With the handle open, pull the knob back towards yourself; Fig. 13
5. Turn it in a clockwise direction until it is blocked. Fig. 14
6. Open or close the gate manually;
7. To block the speed reducer, turn the knob in an anticlockwise
direction until it is blocked.
8. Re-insert the knob in the handle.
9. Close the handle with slight pressure. The handle can be closed
even with the motor released.

6) Testing

To test the KS2 follow this procedure:
• Make sure that the fusible elements are in good condition.
• Check that the lock is not rusted and that no friction exists when
the key is turned.
• Check that the release manoeuvre is performed easily.
• Check that there are no rusted parts inside the selector switch.
• Check that all electrical connections are in good condition.
• Check that all screwed connections are well tightened..
• Check correct contact operation.

7) Maintenance

KS2 does not require any special maintenance, apart from a regular
scheduled maintenance control at least every six months to check
condition as described above (presence of damp, rust, etc) followed
by the standard test procedure.
COURTESY
OPEN
LIGHT
GB
CLOSE
5