Storage And Disposal; Storing The Device; Disposing Of The Device; Technical Data - Mennekes 3KRAFT Montage & Betriebsanleitung

Risk of loss of life from electric shock!
When replacing a safety fuse, energised components can
be touched. There is danger of severe or fatal injury.
• When replacing a safety fuse, do not reach into the
automatic circuit breaker, since it is under voltage.
• Immediately install a new safety fuse in order to restore
the protection against accidental contact.
• Insert a new, equivalent safety fuse.
The miniature circuit breaker and / or a safety fuse are
triggered again.
• Take the receptacle combination out of service and do not
use it anymore.
• Take the consumer out of service and not use it anymore.
• Have an electrician rectify the problem.

12. Storage and disposal

12.1 Storing the device

For proper storage and to ensure trouble-free operation
of the device at a later time, the following points must be
observed:
• Clean the device before placing it into storage.
Ö
Please refer to the "Cleaning" chapter
• Pack the device in the original packaging or a suitable
cardboard box.
• Store the device in a dry and temperature-controlled room
at a temperature range 0 °C to +40 °C.

12.2 Disposing of the device

When the device reaches the end of its useful life it must
be properly disposed of. Do not dispose of the device in
the usual household waste. In accordance with European
Directive 2002/96/EC concerning Waste Electrical and
Electronic Equipment and its implementation in national
law, electrical devices that are no longer capable of being
used must be collected separately and recycled in an envi-
ronmentally responsible manner.
Moreover, the applicable national statutory regulations and
provisions in the respective country of installation must also
be complied with for its disposal.
Danger

13. Technical Data

13.1 Name Plate

Example:
1
2
3
4
5
6
No.
1 Part number
2 Rated current
3 Rated voltage
4 Frequency
5 Barcode
6 Max. fuse in series
7 Product standard
8 Manufacturing code
9 Protection class (IP)
10 Rated short-circuit current
11 Rated diversity factor (RDF)
13.1 / 1
Apart from the rating plate information also observe the
device-specific connected loads.
Ö
see chapter "Appendix"
Depending on the device version, the data on
the name plate can differ as regards content and
scope. If you have any questions or need further
information, please contact your specialist dealer or
MENNEKES.
11
10
9
7 8
Explanation
EN EN
EN EN
NL NL
FR FR
IT IT
19