Foorseeable Misuse - Mennekes 3KRAFT Montage & Betriebsanleitung

The operator / user must meet and observe the following
requirements:
– Comply with information given in the installation and
operating instructions in all aspects
– Permanent storage of installation and operating instruc-
tions for reference
– Ensure that the device is used as intended
– Instruct persons who use the device
– Recognise risks and avoid possible hazards
– Consult a qualified electrician in the event of failures or
for work which may only be carried out by a qualified
electrician.
– Protect persons (e.g. people with handicaps or children)
who are not able to accurately assess the hazards associa-
ted with using the device.
– Observe the national accident prevention and work pro-
tection regulations
2.4 Foreseeable misuse
To ensure the safe use of the device and to avoid misuse,
the following points must be complied with:
Failure to observe the information given in the instal-
lation and operating instructions
• Observe all of the information given in the installation and
operating instructions for carrying out any task.
• Only perform the tasks which are described in these
installation and operating instructions.
• Observe the procedure and sequence for the described
work steps.
Installation work on the device with the supply volta-
ge switched on (electrician!)
• Switch off the supply voltage before commencing
installation work on the device.
Improper procedures for putting the device into
service and taking it out of service
• Only have a qualified electrician put the device into service
and take it out of service.
Ö
Please refer to the chapters "Installation and start-up"
as well as "Taking out of service and dismantling"
Operation of the device under unsuitable ambient
conditions
• Only operate the device under the ambient conditions that
have been approved and are suitable for this.
Ö
Please refer to the "Technical Data" chapter
Operation of a device that has not been completely
installed, is damaged, or incorrectly connected
• Only have a qualified electrician connect the device, put it
into service and maintain it.
• Only operate the device, if it has been completely installed,
is undamaged, and if an electrician has executed the
proper start-up procedure.
Suspending device on own supply line
• Do not suspend the device on the own supply line in order
to avoid mechanical stress on the supply line.
Manipulation of the device
• Do not remove any parts of the device.
• Do not perform any modification to or conversion of the
device.
Use of the device for storage
• Do not cover the device with objects.
• Do not put objects on the device.
Use of unsuitable cleaning agents
• Obtain prior approval from MENNEKES for cleaning agents
you would like to use.
Use of unapproved replacement parts and accessories
• Only use replacement parts and accessories manufactured
and/or approved by MENNEKES.
EN EN
EN EN
NL NL
FR FR
IT IT
5