Precautions - I-SUP HT-781 Bedienungsanleitung

i-SUP INTELLIGENT ELEKTRIC AIRPUMP
Notice: The factory set pressure value of the air pump is 10PSI
*
(10PSI=0.689BAR), and at the time of the secondary use, the set
pressure value for the last time use will be displayed by default.
Notice: After powered on, if there is no operation within 2 minutes, the
*
air pump will enter standby mode, and the machine can be initiated
by pressing the power switch button
VI. Precautions
The applied power source must be the 12V DC power source (as
*
Figure 3).
Don't block the air inlet (10) at the bottom of the air pump, and
*
guarantee air inlet (10) to be always unblocked.
Observe the local waste treatment provisions, and it is not allowed
*
to throw the air pump away randomly.
Don't use this product when the hose is damaged, and please
*
change the hose immediately.
Don't pull out the hose when inflating, because that the high
*
pressure may hurt the physical body.
Don't make the air pump work for more than 15 minutes, because
*
that motor overheating may cause internal damage; and the air
pump shall be fully cooled for 30 minutes after continuously working
up to 15 minutes.
Please don't use this air pump if any part is damaged, and please
*
contact with the professional personnel to repair it.
This product shall not be exposed to the rain or immersed in water.
*
In order to prevent risk, the inflation inlet shall not be forward to face
*
or body.
Please don't not leave while inflating.
*
Please start the car when using the product, in case of unnecessary
*
damage.
.
igure 3
14