Inflation Operation - I-SUP HT-781 Bedienungsanleitung

i-SUP INTELLIGENT ELECTRIC AIRPUMP
V. Inflation Operation
Connect the end with Flexible conduit adaptor of the hose with the air
*
pump inflation inlet (1), and twist clockwise to tighten it, as Figure 1.
Install the other end of the hose into the supporting air tap of the air
*
bag (step
insert the inflation valve of the air bag and twist clockwise to fix it
(step in Figure 2).
Plug the DC plug into the 12V DC socket.
*
Press the pressure unit toggle button
*
Press the pressurizing button
*
the pressure value you need, with the range of the pressure value
from 0 to 16PSI, (1PSI=0.0689BAR)
After finishing the above steps, press the power switch button
*
to start to inflate.
During the inflating process, you can press the pressurizing button
*
or decompressing button
value, press the pressure unit toggle button
press the On/Off button
When the pressure reaches the set value, the air pump will stop working
*
automatically.
After completing the inflation, pull out the DC plug from the 12V DC
*
socket.
After pulling out the DC plug, please take down the hose from the air
*
pump and air bag and store it.
in Figure 2), and twist clockwise to tighten it, and then
gure 1
to select the unit you need.
or decompressing button
to increase or reduce the pressure
to stop.
13
to switch the unit, and
gure 2
to set