Jeti DUPLEX Serie-2.4EX Bedienungsanleitung Seite 19

- PPM Alarm Code:
reports absence of the connected signal. By means of loading a morsealphabet character tones are set, which
acoustically announce the absence of the PPM signal at the particular receiver input. These acoustic signals are
generated by the transmitter module.
-Set Input Channel: function affiliation to particular outputs, any input channel or its mixing product which
may be specified in the menu Channel Set can be set up.
-Reverse A: makes throw reverse at the output in the half plane A possible, the half planes are subdivided
according to the neutral position setup (Channel set - Set Center)
-Reverse B: makes throw reverse at the output in the half plane B possible
-Gain A: Amplification of the output throw in half plane A (100% - without changes)
-Gain B: Amplification of the output throw in half plane B (100% - without changes)
-Signal Fault: setup of the receiver behaviour in case of signal loss, repeat- repetition of the last valid throw
positions, out off – output switched off, FailSafe – transition to preset throw positions of individual outputs which
may be set up in the FailSafe menu.
-FailSafe: throw setup of a selected output in case of signal loss
-Delay: delay of servo speed (at the output) in case of a change at the input, the entry time corresponds with
the transit time within the output range between 1ms to 2ms which, for instance, may be suitable for
retracting a landing gear
-Curve: Setup of a channel output curve
-ATV High Limit: restriction (reduction) of the maximum throw of a particular output (half plane B)
-ATV Low Limit: restriction (reduction) of the maximum throw of a particular output (half plane A)
-Output Group: setup of a particular output for a selected group of output pulses, which are generated by the
receiver at the same time . See page 56.
Auto Set: complete receiver preset for predefined functions. After selection of the desired function the receiver
setup is executed by simultaneous pressing of the left and right JETIBOX keys for about 3 seconds.
-Normal: basic setup, mixers switched off, individual input channels are affiliated to corresponding outputs, i. e.
input CH1 is affiliated to output Y1 etc.
-MixCH1&CH2 Elevon: affiliates the mix of the received CH1 and CH2 to the output channels Y1 and Y2
-MixCH2&CH4 V-Tail: affiliates the mix of the received CH2 and CH4 to the output channels Y2 and Y4
Receiver
PPM IN
SAT 1
PPM OUT
OUT Yx
PPM IN
SAT 2
PPM OUT
OUT Yx
if one of the outputs SAT1/2 is set to PPM input mode, an acoustic signal can be set up which
R9
•
–
–
–
–
–
Receivers
R10 R11EPC
• •
– –
Y11
–
• –
• –
– –
R12EPC R14
• •
– –
– –
• •
• •
Y12 –
EN
R18
•
–
Y18
•
•
Y17