Installing The Seat Cover; Operation - Waeco MagicComfort MBJ05 Montage- Und Bedienungsanleitung

MBJ-05-24.book Seite 15 Freitag, 8. September 2006 5:07 17
MBJ05
5

Installing the seat cover

The seat cover and the connection cable must be attached for use
in the vehicle in such a way that the driver's freedom of movement
is not impaired.
➤ Secure the seat cover to the back rest of the seat using the strap (see
fig. 5, page 4).
➤ Secure the seat cover to the seat area using the rubber straps and the
hooks supplied (see fig. 5, page 4).
➤ Connect the 24 V plug (see fig. 3, page 3) to a 24 V socket in the vehicle
(see fig. 2, page 3).
The 24 V plug has an adapter sleeve. This means the plug can fit
sockets of different sizes (see fig. 4, page 4).
➤ Switch on the seat cover using the main switch (see fig. 3 1, page 3).
➤ To switch off the seat cover, turn off the main switch and unplug the power
lead.
6

Operation

The first few times you use the seat cover, only use the massage
function for periods of 3 to 5 minutes. First accustom yourself to
the vibrations with long massage impulses.
The functions of the seat cover are controlled using the control unit (see
fig. 1, page 3). The following controls are available:
Item in
Function
fig. 1
1 Impulse control
2 Massage
intensity
3 Zone control
Installing the seat cover
Switch position/operating mode
Top: continuous massage
Middle: short massage impulses
Bottom: long massage impulses
Top: massage off
Anticlockwise: lower intensity
Clockwise: higher intensity
Top: all 5 massage areas vibrate
Middle: no massage function
Bottom: only the massage units in the
lumbar area vibrate
15