Technical Specifications; Introduction And Features - ProPlus 550142 Gebrauchsanweisung

TECHNICAL SPECIFICATIONS

12V 2Amp. 3-charging cycle
40
INPUT: AC 220V-240V
OUTPUT: Max. 14.4V DC 2A
Ah
12 3
Max. 40Ah
- MCU built in, fully automatic from charge to maintenance.
- Charge WET, GEL & AGM type load-acid batteries.
- For 12V Batteries.
- 3 stage charge program, safer and faster.
Max. 14.4V DC 2A

INTRODUCTION AND FEATURES

This charger recharge battery with 3 stage.
STAGE 1 - BULK/RAPID START CHARGE (20%-70% charge, "Charging" is on)
The charger delivers maximum charging amperage to "wake up" any 12 Volt battery. When it reaches a
maximum safe predetermined voltage, the digital sensors automatically move into stage 2 of the charging
process.
STAGE 2 - ABSORPTION CHARGE (70%-90% charge, "Charging" is on)
Maintains the charge at a constant safe voltage. During this (stage 2) voltage absorption regulation charge,
the charging voltage remains constant, while the actual charging current is reduced to allow for the
maximum proper internal chemical energy transfer.
STAGE 3 - TOP-OFF CHARGE (90%-100% charge , "FULL" is on)
Voltage is automatically maintained and reduced to a predetermined level while current is adjusted for a
safe, effective 100% charge (step-down regulation mode). Ideal for topping off batteries that have been in
storage. Automatic shut-off at 100% charge - you can trust this charger to never overcharge any battery,
or cause pressure leaking of acid, even if it is left unattended while charging in hot summer temperatures.
17