Go/on S1M-KM18-125C-A Übersetzung Der Originalbetriebsanleitung Seite 67

Original Instruction Manual En
Please always check the mains supply voltage before use! It must correspond with the
rating label on the appliance.
Remove any packing material and loose parts from unit.
Check the accessories before use. It should be fit with the machine and your purpose.
Make sure that the workpiece is always firmly held and remains stationary
through if needed a fastening system during the entire use of the machine.
Disc guard
CAUTION! The machine should be used only with guard.
The position of the disc guard can be adjusted to suit the working conditions.
To do this, please follow below steps:
1. Loosen the screw with the spanner.
2. Turn the guard to the desired position.
3. Retighten the screw firmly.
WARNING
The closed disc guard should always point towards the user to protect him from sparks
and chippings.
Auxiliary handle
CAUTION! The machine should be used only with both handles.
Depending on the working method, the auxiliary handle can be mounted in two
different positions on the grinding head.
Do not continue to use an auxiliary handle if it is damaged.
Disc selection
Do not use accessories which are not specifically designed!
Please always double check the disc which will be assembly. It must fit for proposes.
WARNING!
NEVER USE A CUTTING DISC FOR GRINDING.
NEVER USE A GRINDING DISC FOR CUTTING.
Mounting disc
Depending on the working conditional, always select a suitable type and thickness of
the disc.
The mounting hole of disc must fit with the mounting flange. Do not use reducers or
adapters.
The direction-of-rotation arrow on disc and machine (see direction-of-rotation arrow on
the machine head) should be same.
CAUTION!
Never use discs whose diameter is larger than that indicated.
The maximum rotation speed of disc must be greater than the idling speed of the
machine.
CAUTION! Never use the grinding disk for cutting.
9 01/2017