Rules For Shredding; Servicing And Maintenance; Changing Blades - Gloria natura 2800 L Betriebsanleitung

976 165-02_Innen:976 165-01_Innen
GB

Rules for Shredding

Please observe local regulations on
operating hours, if applicable.
Servicing and
Maintenance
Pull out the mains plug before be-
ginning any work on the machine!
Clean the shredder with a hand brush or
a damp cloth.
Spray the blades and bolts with an anti-
corrosive agent.
Check all screws periodically for a tight
fit and retighten when necessary.
Store the unit in a dry place.
The machine may not be cleaned
with a high-pressure cleaner or a
strong jet of water.
To transport the shredder in a passen-
ger car, remove the upper part of the
housing 12 as follows:
G loosen star screw 11.
G turn upper part of housing 12 90° and
lift it out of the articulated fork (fig. B).
02.11.2010
Do not tilt upper part of hous-
ing 12 when lifting it out or replacing
it.

Changing blades

A
Loosen star screw 11.
B
Remove upper part of housing 12
as described.
C
Block blade plate 13. Using a socket
wrench, loosen the nuts M 16 (24mm)
by turning to the left. When assembling,
make sure the nuts are tight. Required
torque 100 Nm. Fit the nuts only with a
locking ring.
D
Remove the blade plate 13 from the
shaft using a rod iron and open-jawed
spanner.
E
Remove the triangular blades 14 using
a hexagon socket wrench, turn it and
replace it with the sharp edge up.
24
11:12 Uhr Seite 24