Installation; Operation; Connection With The Mains - EuroLite RF-1200 Bedienungsanleitung

INSTALLATION

Install the device out of the public area.
Only install the machine on scratch resistant surfaces.
This device is constructed for a standing installation only.
The device must only be installed absolutely planar at a vibration-free, oscillation-free and fire-resistant
location.
As described above, you have the possibility to adjust the air output direction by the housing angle.
Select the air output direction and set the device to the desired position.
The operational surroundings must be free from solid or liquid easy-to-move objects, which could be tilted,
absorbed or accelerated by the air flow.

Operation

Connection with the mains

Connect the fixture to the mains with the power-plug.
The occupation of the connection-cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Set the rotary switch to 0.
Connect the effect to the mains.
Switch the device on.
You can adjust three different speeds:
Level 1 – high,
Level 2 – medium
Level 3 – low
International
L
N
13/14 00027967, Version 1.1