Install The Receiver / The Battery; Install The Battery - Staufenbiel EDGE 540 Anleitung

EN
INSTALL THE RECEIVER
1. Attach the aileron control horn to the Y-Harness in
the fuselage.
Note: There is no difference between the two plugs
on the Y-Harness.
2. Attach aileron servo to the Aileron channel of your
receiver. Elevator plug goes to elevator channel
of your receiver. Rudder servo goes to the Rudder
channel. Attach the ESC connector to the Throttle
channel of the receiver.
3. Attach the receiver to the receiver hatch using the
velcro tape.

INSTALL THE BATTERY

Slide the battery into the battery hatch with the power
supply cable toward the rear end of the plane and
secure it using the pre installed hook and loop tape.
Note: You may need to relocate the battery posi-
tion to achieve the correct CG for your Edge 540
model.
29