14.2 Removing of pistons
➁
➂
Z
➃
➄
for cleaning or replacing
1. Disconnect the manifold from the handle.
2. Turn both closures of the manifold housing cover 90° (e.g.,
using a coin) and slide off the housing.
3. Remove both outer Phillips screws on the nose cone assembly.
Attention:
Do not loosen the central guide rod (Z)!
4. Pull the piston and nose cone assembly apart and separate.
Remove stroke springs.
5. Place the mounting tool on the piston nut and unscrew the
piston nut.
37