Absaar LP011 Gebrauchsanweisung Seite 6

Absaar_77101_Bed.:Lay
User instructions
Attention, possible
malfunctions
6
21.07.2011 11:28 Uhr
Installation of the control unit and display
1. Fix the control unit to one side of the boot with double-sided tape in such
a way that it is not exposed to high temperatures, humidity or water
penetration and that it does not come into contact with metal or electro-
magnetic devices
2. Stick the base of the display on the dashboard so that it is in the driver's
preferred angle of view. Connect the display and the cigarette lighter
socket with the cable supplied.
Installing the power cables
1. Connect the red cable of the control unit to the positive pin (+) of the
reversing light. Connect the black cable of the control unit to the negative
pin (–) of the reversing light.
2. As an option, you can install the display with a permanent connection.
Disconnect the connector for the cigarette lighter socket. Connect the red
cable of the display to the positive pin (+) of the ignition or of the reversing
light. Connect the black cable of the display to the negative pin (–) of the
ignition.
I. Display
1. A warning device emits warning sounds.
2. When you are reversing the car to park, the display will automatically
show a distance of up to 2 m to the obstacle behind the car. At a distance
of between 1.5 m and 0.8 m, beeps are emitted at longer intervals.
At a distance of between 0.8 m and 0.4 m, beeps are emitted at shorter
intervals. At a distance of less than 0.4 m, a continuous beep is emitted.
3. Two „ "symbols at the bottom of the LED display show the direction in
which the obstacle is located. If the obstacle is located on the left, the left
„ "symbol lights up. If the obstacle is on the right, the right „ "symbol
lights up.
Sloping
surface
Seite 6
Spherical
objects
Sound-absorbing
materials