Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
The technical data are not binding and not expressly warranted
characteristics of the goods. They are subject to change. Please
consult our General Conditions of Supply.
1.
Manufacturer's declaration
Modifications to the fusion device which have an effect on
the technical data given and its intended use render this
manufacturer's declaration null and void. Additional information
can be found in the Technical Manual of Building Technology.
2.
Attention
Please take the time to read through this Instruction Manual
carefully as it contains important information and tips.
3.
Table of contents
1.
Manufacturer's declaration
2.
Congratulations on your purchase Scope of delivery
3.
Table of contents with page reference
4.
Safety information
4.1. Explanation of symbols
4.2. General safety
4.3.
User requirements and operator responsibility
4.4. Special hazards
4.5. Transport and storage
5.
Intended use
6.
General product information
14
4.
Safety information
4.1
Explanation of symbols
Hazardnoticesareusedinthisinstructionmanualtowarn
you of possible injuries or damages to property. Please read
and heed these warnings at all times.
Imminent danger! Failure to comply could result in death or
extremely serious injury.
4.2 User requirements
and operator responsibility
When fusion is performed with the HWSG 3, the
planner/installer of the INSTAFLEX system is responsible for
warrantingthat:
• the HWSG 3 is used only as intended.
• operation, maintenance and repair are conducted by
authorized personnel only.
• personnel receives periodic instruction in occupational
safety and environment protection.
• personnel is familiar with the instruction manual and
adherestotheinstructionscontainedtherein
4.3
Transport and storage
The HWSG 3 is to be handled, transported and stored with
duecare:
• The HWSG 3 should be transported and stored in its
original packaging.
• When storing the HWSG 3, it should be protected against
detrimental effects, such as dust, dirt and humidity.
5.
Intended use
The HWSG 3 fusion device is intended exclusively for joining
electrofusion fittings (HWS) and PB pipes in the INSTAFLEX
system.
.
15
Werbung
Inhaltsverzeichnis
