Gebrauchsanleitung Hochbett KIM ohne RT
Instructions for use high bed KIM
Das Bett sollte von 2 Personen aufgebaut werden.
Wichtig!
Bitte lesen Sie die Gebrauchsanleitung mit
den Warn-und Sicherheitshinweisen vor dem Aufbau
des Bettes sorgfältig durch und bewahren Sie diese
danach auf.
Die Gebrauchsanleitung beinhaltet darüber hinaus
eine Montageanleitung mit einer Stückliste, sowie die
notwendigen Werkzeuge für einen sicheren Zusam-
menbau Ihres Bettes.
Warn- und Sicherheitshinweise:
1. Achten Sie beim Zusammenbau des Bettes darauf,
dass die Verbindungselemente fest angezogen wer-
den. Die Verbindungselemente müssen auch wäh-
rend des Gebrauchs auf Ihren festen Sitz kontrolliert
werden.
2. Die horizontale Kerbe in dem Bettpfosten
(Seite 7/7) kennzeichnet die maximale Matratzenhö-
he. Diese Kennzeichnung muss bei innenliegender
Matratze weiterhin zu sehen sein. Dann bleibt Ihr Bett
sicher.
Die empfohlene Matratzengröße ist 900 x 2000mm.
Die max. Matratzenhöhe beträgt 190 mm.
3. Das Bett darf nicht benutzt werden, wenn ein Bau-
teil fehlt oder gebrochen ist.
4. Hochbetten und das obere Bett von Etagenbetten
darf von Kindern unter 6 Jahren nicht benutzt werden!!
Es besteht eine Verletzungsgefahr beim Herunterfal-
len.
5. Folgende Gegenstände dürfen nicht am Bett
befestigt oder angehängt werden: Stricke, Schnüre,
Kordeln, Gurte, Bänder etc. Es besteht Strangulations-
gefahr!!
6. Achten Sie darauf, dass das Etagen- oder Hochbett
immer mit der Wand in Berührung sein muss. Falls
dies nicht möglich ist, darf der Abstand zwischen der
Oberkante der Absturzsicherung und der Wand höchs-
tens 75 mm betragen oder der Abstand muss größer
sein als 230 mm.
Das Bett darf nur mit einem
feuchten Lappen gereinigt werden.
Das Bett entspricht der DIN EN 747-1:2007
- ID. Kennung; Hochbett KIM ohne Rutsche
- ID. NO. KS / cod - 005 / 11
- Massivholz Buche
Relita Dr. Woite GmbH & Co. KG
Entspricht der DIN EN 747 Ausgabe 2007
11 05 73448 006
The bed should be assembled by 2 persons.
Important!
Please read the instructions with the
warnings and safety instructions thoroughly prior to as-
sembly of the bed and retain them carefully for further
reference.
The manual also includes assembly instructions with
part lists and information on the necessary tools for
safe assembly of your bed.
Warning and Safety
1. When assembling the bed take care that the screws
must be regularly checked during the use of the bed.
2. The horizontal notch on the bedpost (Page 7/7)
indicates the maximum mattress height. This identi-
bed, and then your bed is still safe.
The recommended mattress size is 900 x 2000mm.
The max. mattress height is 190 mm.
3. The bed should not be used if any component is
broken.
4. High beds and the upper bed of bunk beds must not
be used by children under 6 years! There is a risk of
injury for these children when falling off.
5. The following items must neither be attached to
the bed nor suspended: ropes, cords, straps, ribbons,
tapes, etc. There is a risk of strangulation!
6. Make sure that the bunk or high bed is always in
contact with the wall. If this is not possible, the dis-
tance between the top of fall protection and the wann
must not exceed a maximum of 75 mm or the distance
must be greater than 230 mm.
Maintenance:
The bed should be cleaned with a
damp cloth.
The bed is in accordance with DIN EN 747-1:2007
- ID. Recognition; High bed KIM
- ID. NO. KS / cod - 005 / 11
- Solid beech wood
Stand 08. 04. 2011
1a/7