Werbung
Verfügbare Sprachen
Verfügbare Sprachen
24195 Speaker wall/ ceiling mount
- For speakers:
-
a. up to 15 kg
-
b. w/two screw sockets M5 (73 - 83 mm / 3")
- adjustable in direction & tilting angle
SAFETY INSTRUCTIONS
- Check for damage prior to and after use. Damaged mounts may not be used again.
- Not suitable for outdoor or moist rooms.
- Observe the local mounting regulations (they may deviate from the examples presented here).
- Only mount on suitable walls with the corresponding assembly material (not incl. in the delivery).
-
Examples - see A, B, C. Observe the placement instructions provided by the anchor
-
manufacturer.
- Walls that are too weak or have electrical and water conduits are unsuitable.
-
In case of doubt consult a qualified technician.
- Only use trained technicians to assemble the system.
- Ensure that the screws are tight and load-bearing, in particular as regards the setting
-
of the loudspeaker angle.
- Only be used with suitable loudspeakers and monitors. Weight: max.: 15 kg
- The placement of the loudspeakers requires two physically fit qualified technicians.
-
One person is to hold and secure the loudspeaker, while the other persons adjusts the tray,
-
and clamps the loudspeakers securely into place.
- Careful and attentive handling is required when adjusting the stand - due to the possibility
-
of pinching or wedging your hand
- External influences such as bumping into the loudspeakers, brushing into the loudspeakers,
-
things thrown at the loudspeaker, wind etc. represent a risk and must be avoided.
-
Measures: Compliance with safety distances, keeping unauthorized persons at a distance,
-
if needed put up safety cordons.
- The instruction provides directions to all of the important setup and handling steps.
-
We recommend, you keep these instructions for future reference.
INSTALLATION INSTRUCTIONS
WALL MOUNTING - examples A, B, C
A
Concrete / perforated brick wall
1.
Ensure that the wall plate (95 x 170 mm) is vertical,
mark drill holes.
Concrete wall - e.g.: anchor bolt M6 x 65 mm
Drill and blow out hole, place anchor, wall plate
and washer, tighten hex nut
2.
Drill the holes for the wall plugs
(4 x 65/140 mm)
-ø 6 mm for anchor bolts (concrete wall)
-ø 8 mm for dowels (perforated bricks)
Perforated bricks - e.g.: universal frame fixing set
8 x 80 mm
Drill countersink and blow out hole, place anchor
and bracket, fix hexagon head wood screw
B
Wooden beams
1.
Ensure that the wall plate is
vertical, mark drill holes.
Wooden beams - e.g.: wood screw DIN 571 ø 4 mm
Drill, countersink and blow out hole, place wall plate, fix
hexagon head wood screw
C
Injection-molded anchor
- without sieve bushing for concrete wall
- with sieve bushing for perforated bricks or optional with
threaded bolt M6 or threaded bushing M6
For exact installation instructions, please refer to the
information supplied with the products.
2.
Drill the holes
- ø 4 mm for wood screw
DIN 571 ø 6 mm
Werbung
