Berker 2fach 16 A Bedienungsanleitung Seite 26

GB
Connect the bus with the bus terminal (Fig. 1, 3).

The connection to different phase conductors is possible.
For current detection, the device is equipped with contactless
current sensors. Magnetic fields in the immediate vicinity can
result in false current measurement results. If possible, lay feed
and return line closely side by side. Do not install devices pro-
ducing magnetic fields in the immediate vicinity of the actuator,
e. g. doorbell transformer, power contactor, etc.
Sliding on the protective cap
To protect the bus lines against dangerous voltages at the con-
necting terminal, slide on the protective cap.
Lead out the bus line at the rear of the device.

Slide the cap over the bus terminal (Fig. 3 A) until it is heard to

engage.
Removing the cap
Press the sides of cap and withdraw (Fig. 3 B).

26
Information for qualified electricians