Industrial Scientific 17154524-1 Bedienungsanleitung Seite 6

Introduction
Table 2 Warnings and cautionary statements
General
For maximum safety and optimal performance of this equipment, read and understand the manual before use. Failure to
perform certain procedures or note certain conditions may impair the performance of this product.
When sample tubing is connected to the pump and the pump is powered on, it continues to draw sample gas even if the pump
door is open. This can cause an unsafe condition. Remove the sample tubing from the pump inlet or power off the pump
before opening the pump door.
When the pump is powered on and no instrument is installed, the pump continues to draw sample gas. This can cause an
unsafe condition. Power off the pump before removing the instrument.
Service the unit and replace or charge the battery packs only in an area known to be nonhazardous. Not for use in oxygen-
enriched atmospheres.
Insert the alkaline batteries with the correct positive (+) and negative (-) orientation. The Ventis Slide-on Pump is approved for
use with the AAA alkaline battery types Energizer EN92 and Duracell MN2400 only. Do not mix battery types.
IECEx and MSHA
Replace battery packs with these part numbers only.
IECEx: 17148313-1, 17134453-X1, 17138041, or 17050608.
MSHA: 17148313-2, 17134453-X2, 17138041, or 17050608.
Alkaline battery pack part numbers 17150608 and 17138041 are only approved for use with three AAA battery types Duracell
MN2400 and Energizer EN92. Replace all batteries at the same time.
4