Atomik Brian Deegan Metal Mulisha Anleitung Seite 6

Atomik-RC.Com
1) Install 4 AA batteries into transmitter.
2) Turn transmitter ON.
3) Connect battery to the ESC. Turn On ESC. After 1-2 seconds the motor will
beep, indicating power is applied and is working properly.
4) Move steering controls right and left to ensure the model is reacting
correctly to inputs. If not, reverse the servo direction. Refer to the photo
above to find the servo-reversing switch.
5) Adjust the steering trim until both wheels appear even. Consult the drawing
below for how to adjust the steering trim.
6) While holding the model elevated off the ground, give throttle and brake
inputs on the transmitter to ensure your model is reacting accordingly.
7) The transmitter should always be turned ON first and OFF last. (Be sure to
unplug your battery.)
5
C opyr ig ht © 2012 Ato mi k r C