Troubleshooting - SOLIS AIRWASHER QUBIC Bedienungsanleitung

STORAGE
s
Check if the appliance is switched off and the power plug is pulled resp. the
●
power cord is removed. The water has to be drained completely.
Check if the appliance inside is completely clean and dry. If necessary, let the
●
appliance stand open until the humidification disks and the water tub are dry
on the inside.
Keep the appliance standing upright in a dry, dark spot, best in the original
●
packaging. Do not place anything on the appliance.
GB
Always keep the appliance and power cord out of the reach of children.
●
96

TROUBLESHOOTING

s
Problem Possible cause
Little – The function SL or LO
humidification resp. 40 % has been set.
power.
– The water in the water
tub is very cold.
No – The power plug is not
humidification connected to the socket.
power.
– First, the warning light
NO! and ■
lit up,
■ ■
■ ■
then the appliance and
all displays switched off.
An indepen- – Dirt has collected in
dent humidity the air outlet or inlet
switch measu- opening.
res a different
humidity value
from the dis-
play on the
appliance.
– The appliance is placed
near a window or an
open door.
The escaping – There is old water in the
air smells water tub / water tank.
unpleasantly.
Solution
– Select a higher humidification
power, e. g. 60 % or 70 % or a
higher ventilation speed MI or HI.
– Select the humidification power
60 % or 70 %. After 10 minutes,
GB
humidification power will have
increased.
– Firmly connect the power plug
to the socket.
– Switch the appliance off.
Fill the water tank up with
fresh tap water, then switch
the appliance on again.
– Clean the air inlet and outlet
openings. NOTE: Even within one
room, different values for humi-
dity can be measured. The value
on the appliance refers always to
the humidity exactly by the appli-
ance.
– Place the appliance in a spot free
of draft.
– Drain the water and clean the
appliance as described in
" Cleaning and maintenance " .
Fill the water tank with fresh tap
water.
97