T Im Er Function Butto N - SOLIS AIRWASHER QUBIC Bedienungsanleitung

HUM IDI FIC AT IO N PO WE R BU TTON
You can use this button to set the desired room humidity. The following settings
●
are possible:
40 % 50 % 60 %
Each touch of the button increases the value by 10 %. Above 70 %, the conti-
●
nuous humidification (CO) is activated. If the set value (between 40 % and 70 %)
exceeds the current room humidity, the appliance works in the set ventilation
speed to achieve the set value. Once the set value has been reached, the appli-
ance stops. It reactivates if the room humidity drops below the set value.
GB
In the CO function, the room air is humidified continuously without a concrete
●
value having to be set.
Touching the button again after the CO setting will return the appliance to the
●
40 % setting.

T IM ER FUNCTION BUTTO N

The timer function is deactivated in the standard setting 00h.
●
button, 01h lights up for one hour. Each touch of the
Once you touch the
●
button increases the value by one hour until a maximum of 12 hours is reached.
After that, 00h lights up in the display and the timer is deactivated again.
When the desired humidification time resp. the set hours have elapsed, the
●
appliance switches off without a sound signal.
NI GHT M ODE BUT TON
With this button, you can activate the night mode, meaning that the appliance
●
switches to slow ventilation speed SL while all the other settings stay intact.
However, there is no sound signal when the water shortage alarm is sounded,
the display merely states NO! in alternation with the three bars ■
nobody will be woken up by the appliance. If you have activated night mode,
only the night mode button and the ON/OFF button can be operated, all the
other buttons are locked.
If you wish to activate night mode, touch the
●
in the display, then the display is dimmed down before going dark completely.
If you wish to deactivate night mode, touch the
●
three times in the display and the appliance switches back to the most recent
settings. The display lights up normally.
88
70 % CO for continuous humidification
. Like that,
■ ■
■ ■
button. ZZZ flashes five times
button again, ZZZ flashes
"W AT ER SHO RTAG E" D ISPLAY
Once you activate the appliance, the Airwasher checks if there is enough water
●
in the water tub. Should this not be the case, it automatically switches to the
water shortage safety function. This is also the case if the appliance runs dry
during use, in this case, the appliance switches to water shortage safety function
within 6 seconds.
In the water shortage safety function, the main motor switches off. The display
●
states NO! in alternation with ■
■ ■
heard, again after 30 seconds and again after further 30 seconds. Then, the
appliance switches to standby mode, the display goes out.
In the water shortage safety function, only the ON/OFF button
●
rated.
FI LL ING WA TER I NTO THE W ATER TAN K
Switch the appliance off with the ON / OFF button
●
appliance backside with the handhold by first tilting it outwards at the top and
then lifting it up and away. Turn the water tank upside down, open the tank
lid and fill the water tank with fresh tap water. Then, close the tank with the lid
and lock the tank back into the appliance.
. Simultaneously, sound signals can be
■ ■
;
can be ope-
;
. Carefully remove the upper
GB
89