Setting Formula Parameters In Manual Mode - Agu PMBF2 Bedienungsanleitung

NEW FORMULA = NEW PARAMETERS.
It is enough to scan a new barcode from the package to change the
parameters of a formula

SETTING FORMULA PARAMETERS IN MANUAL MODE

To configure the device without using a smartphone, follow these steps:
1. Go to the site on the following route:
agu-baby.com → products → MACHINE FOR THE PREPARATION OF
BABY FORMULA → Formula database.
Find the formula that you are using at the moment. You will be provided
with the following information: water volume, preparation temperature,
formula, preparation program for a given volume of water.
2. Before starting to operate the unit, check if there is powder in the
powder container.
ATTENTION
In the container should be at least 30–40 grams of the mixture for the
correct preparation of the formula.
3. Fill the water container. The temperature of the water must be several
degrees below the formula preparation temperature; otherwise, the
machine will be in a standby mode until the water cools. In this case, the
indicator of the button «Warm water» will flash. For correct operation
of the machine, use baby (bottled) boiled water at room temperature,
about 25 °C.
4. Place the water tank under the funnel.
5. Turn on the device.
EN
59