Calibration - Wohler TI 410 Bedienungsanleitung

Calibration

10 Calibration
If the device does not work correctly duri
operability test described in chapter 6, a reca
tion will be necessary
Before starting the cali
vice as described in
tons "SEN S" an "ON/OFF" at the same time, to
ente r the calibration m
pear at the ri ght bottom of the displ
NOTE!
If the calibration mode w
can be deactivated by pressing the "SENS" button
without changing the calibration.
During the calibration, the TI 410 shows con-
stantly the raw data of the condensation sensor.
Hold the sensor above a water quench with a
temperature that is approximately 10 °C higher
than the room temperature. The measuring sign
should increase considerably and stabilize after
some seconds.
As soon as the signal has stabilized, the meas-
urement must be stopped by pressing "HOLD"
After pressing the bu
a t the same time, the actual measured value will
be assumed as the reference value. This will be
shown in the Display by "SAVE".
.
bration, switch on the
c hapter 7.1. Press
ode. The icon "C" will
ay.
as activated by mist
ttons "SENS" and "ON/OFF"
ng the
libra-
de-
the but-
ap-
ake, i t
al
.
24