Monacor TFT-900LED Bedienungsanleitung Seite 11

If the units are to be put out of operation
definitively, take them to a local recycling
plant for a disposal which is not harmful to
the environment.
3 Applications
This TFT LCD monitor with LED backlight illumina-
tion is ideally suited for applications in surveillance
systems, but it can also be used for other purposes,
e. g. as a PC monitor.
The monitor has a metal housing. It requires lit-
tle space and features a high colour brilliance and
precise details. For connecting the signal sources
five inputs (HDMI TM , VGA , S-Video and 2 × BNC)
are available. Feed-through outputs allow to route
the BNC input signals to further units. In addition,
the monitor has stereo audio inputs and two inte-
grated speakers for audio reproduction. Via an on-
screen menu the unit can perfectly be adapted to
the requirements of the respective application.
The monitor is supplied with
– a base
– a power supply unit with separate mains cable
– a VGA connection cable.
4 Setting-up / Mounting
Set up the monitor by folding up its base on an
even, stable surface. Instead of the base, another
monitor bracket can be used which corresponds to
the VESA-75 standard: Screw off the base and fix
the VESA bracket to the rear side of the monitor
using the four threaded holes arranged at a dis-
tance of 75 mm.
From the ergonomic point of view it is favourable
to position the screen slightly below eye level (up to
15°) at a viewing distance of approx. 50 cm. To pre-
vent annoying reflections, the monitor should be
placed so that light will not fall directly onto the
screen surface.
5 Connections
5.1 Composite video signal sources
The video outputs of two signal sources which sup-
ply a composite video signal may be connected to
the inputs VIDEO 1 and VIDEO 2 (9) via BNC con-
nection cables (e. g. BNC-100*). For audio repro-
duction connect the audio output of one of the
sources to the RCA jacks AUDIO (11) [R = right
channel, L = left channel].
Via the BNC outputs VIDEO 1 and VIDEO 2 (10)
it is possible to route the signal of the respective
BNC input located above, e. g. to the video input of
another monitor or a recorder.
5.2 S-Video signal source
A source which supplies an S-Video signal may be
connected via an S-Video cable (e. g. SVHS-144*)
to the 4-pole mini DIN jack S-VIDEO (12). Connect
the audio output of the source to the RCA jacks
AUDIO (11) [R = right channel, L = left channel].
5.3 Signal source with HDMI
Via the digital interface HDMI
Multimedia Interface") both video data and audio
data are transmitted. If the signal source is pro-
vided with an HDMI TM
preferred as the digital connection generally sup-
plies a higher picture quality. Connect the output of
the signal source to the input HDMI (8) via an
HDMI TM cable (e. g. HDMC-150PRO*).
5.4 Signal source with VGA output
If the source provides its video signal via a VGA
output, connect this output to the 15-pole Sub-D
jack VGA (14) via the VGA cable provided. Connect
the audio output of the source to the 3.5 mm stereo
jack PC AUDIO (13).
5.5 Power supply
Connect the power supply unit provided to the jack
DC12V (15) and connect it to a mains socket
(230 V~/ 50 Hz) via the supplied mains cable. When
connected to the socket, the power supply unit is in
operation, its power LED will light up.
TM output
TM ("High Definition
output, this output should be
* from MONACOR
GB
11