Laser Overview; Keypad Overview; Setup - Agatec A510S Bedienungsanleitung

1.4 Laser overview

See inside front cover for photos of the laser and keypad corre-
sponding to these callouts. See separate descriptions of motorized
mount, remote control, and detectors.
1. Rotating head
2. Aluminum head protection with axes indications
3. Plumb or square laser beam aperture
4. Rotating laser beam aperture
5. Collar to switch between point & chalk line
6. Index marks for alignment and 90°
7. Motorized wall or floor mount
8. Batteries
9. Jack for battery charger
10. 5/8 - 11 tripod mount for horizontal set-up
11. 5/8 - 11 tripod mount for vertical set-up
12. Sensors for remote control signal

1.5 Keypad overview

13. Move left: stationary point, chalk line, scan, or vertical alignment/
Move calibration beam up
14. Move right: stationary point, chalk line, scan, or vertical alignment/
Move calibration beam down
15. Decrease rotation speed or scan angle / Save calibration
16. Increase rotation speed or scan angle / Change calibration axis
17. On / Off
18. H.I. Alert
19. Automatic / Manual mode
20. Low battery LED / X axis calibration LED /
Indicates remote signal received
21. H.I. Alert LED / Y axis calibration LED
22. Manual mode LED / Z axis calibration LED
Italics indicate keys and LEDs used in calibration mode.
6
2. How to use your A510 laser

2.1 Setup

The motorized wall mount and the metal head protection can
both be removed from the laser, if you wish to work without
these attachments.
• Horizontal
The laser can be mounted on a 5/8" tripod (10) or placed
directly on a solid, stable surface. It can also be suspended
from a ceiling grid using the wall mount (see later section).
• Vertical
The laser can be mounted on a 5/8" tripod (11) or placed directly
on its back (opposite the handle) on a solid, stable surface.
For more stability, we recommend you extend the motorized
mount. Use the support plate for stability when in vertical mode.
The A510 has a wide self-leveling range; however, if the laser is set
up out of the leveling range, laser beam will continue to blink and
rotation will not start.
• Turning on the laser
Turn on the laser with the On /Off key (17). It does a self-test and
the beam blinks while the laser is self-leveling. After it's leveled, the
head rotates. You can choose H.I. Alert mode or change to manual
mode (see next section).
7