Grundig WK 7280 W Bedienungsanleitung Seite 17

OPERATION­ ______________________________
Preparation
1­­
C lean kettle well before initial use and discard
the water of first two boiling cycles.
Operation
1­­ P ush the lid release button
open the lid .
C
2­­ F ill the water tank
G
Notes
Do not place the water tank
7
while filling it with water.
Never fill the water tank
7
mum level indicator or below the minimum
level indicator.
3­­
C lose the lid until it clicks into place.
C
4­­ P lace the water tank
sure that it is sitting in an upright and stable
position.
5­­
I nsert the plug into the wall socket.
6­­ S elect the desired temperature by pressing the
selection button . As the button
K
the temperature selection will cycle from 100
to 80, 60, 40 and back to 100 again.
– The temperature indicator light
7­­ I f desired, the simmer function can be acti-
vated by pressing button
– Indicator light of button
Notes
When pressing the simmer function button
7
in stand by mode without selecting the desired
temperature, the indicator light of button
go off after 10 seconds.
8­­ P ush On/Off button
– Indicator light of On/Off button
and the boiling process begins.
– When the appliance is in operation, indica-
tor light of the set temperature will flash.
Meantime, current water temperature will
be indicated by the relevant temperature
indicator light until the set temperature is at-
tained.
on the kettle to
D
with water.
on the base
G
above the maxi-
G
on the base . Make
H
G
is pushed
K
will flash.
L
.
I
lights on.
I
will
I
.
J
lights on
J
Note
Lid should always be closed during the boil-
C
7
ing process; otherwise the kettle will not switch
off automatically.
The desired temperature can be changed or set
7
during the boiling process by pressing tempera-
ture setting button
9­­ W hen the desired temperature is reached, the
indicator light of On/Off button
and the kettle stops operating.
– After 60 seconds the temperature indicator
H
lights
L
stand by mode.
Notes
If you want to stop the boiling process manu-
7
ally, push the On/Off button
If the simmer function is activated, the kettle will
7
restart the boiling process when the tempera-
ture falls below the desired temperature. After
30 minutes, simmer function will be cancelled
automatically.
10­­Disconnect the plug from the wall socket.
11­­Take the water tank from the base
hold it by the handle
Caution
Do not open the lid
7
splash out. Make sure that no water splashes
onto the base
12­­Pour the water from the spout
glass you want to use.
I
Note
Let the kettle cool down between each heating
7
process.
Hints­and­Tips
The kettle is equipped with a water filter
7
which filters out limestone and other residues
when the water is being poured out.
Use softened or filtered water to prevent lime
7
build-up.
.
K
go off and the kettle returns into
.
J
.
E
as hot water could
C
.
H
to the cup or
A
ENGLISH
goes off
J
. Only
H
B
17