Troubleshooting - Maximum MDA-110 Gebrauchsanleitung

➊ ➊ ➊ ➊ Powering the Antenna by a Power Adaptor
(1) Follow one of the antenna placement instructions above
(2) Connect the other end of the coaxial cable to the power inserter.
(3) Connect another end of the power inserter to your Set-Top-Box (or Digital TV set).
(4) Take out the power adaptor, connect to the DC IN of the power inserter (the LED on the
power inserter will indicate the power status), and then connect the other end of the power
adaptor to a power outlet. Please use the provided power adaptor only.
(5) Turn on the STB or TV, and check for the signal.
➋ ➋ ➋ ➋ Powering the Antenna by STB or Digital TV
(1) Follow one of the antenna placement instructions above.
(2) Connect the other end of coaxial cable to the STB or Digital TV directly.
Please note:
※ ※ ※ ※
Please make sure the connected STB (or TV) can support DC 5V powering function through
coaxial cable to antenna. Otherwise, using power adaptor and power inserter for powering.
※ ※ ※ ※
All the connection must be fixed, and it is strongly recommended that you should have a
water-drop loop at the end of the cable.
※ ※ ※ ※
After you complete the installation, you can use your Set Top Box to check the signal strength
and quality. If the quality is not good enough to have good pictures, you can move the antenna to
another location to get the better reception, and then fix it.
For the best reception, please check the following conditions:
1. Keep away from sources of interference: keep away from those large power consumption devices
such as air conditioner, elevator, hair dryer and microwave oven...etc.
2. Installed as high as possible: In the case of digital terrestrial reception, if there are some
interruptions between the antenna and transmission tower, it will cause the signal loss temporary.
So installed the antenna as high as possible to avoid the interruptions.
3. When install this antenna to the exterior of a vehicle or yacht, please make sure the antenna is
fixed appropriately. Max. windspeed: 130 KMH.
1. If you cannot get the digital programs as you expect, please check the following conditions:
a. Check the connection. Make sure all the connection is correct.
b. Check the antenna powering function of your STB or DTV. MDA-110 is an active antenna
(amplifier built-in), so you will need to turn on the power supply function for the antenna. (Please
refer to the operational manual of your STB or DTV.)
c. When apply the antenna for any applications, please make sure you use the power inserter and
power adaptor (included) for antenna powering. Please check the installation illustration as above
for correct antenna powering connection.
2.
Adjust the position of the antenna to find the best signal reception.
NOTICE
TROUBLE SHOOTING
4