Reflexion HRA 4060 Bedienungsanleitung Seite 15

SET UP
☆ Setting the Time
When power cord is plugged in,
•
Press RADIO MEM./ CLOCK SET button for 3 seconds, follow by
format (12 or 24 hours)
•
Press RADIO MEM./ CLOCK SET button again , follow by
•
Repeat above steps to adjust the minute.
•
Press RADIO MEM./ CLOCK SET button to confirm.
☆ Setting the Wake TIMER
This unit includes a timer to wake you up to RADIO, TAPE or BUZZER.
The Wake timer can be set at standby mode only. Ensure the clock has been set to the correct time.
Press TIMER SET button (FOR ALARM SET) on for 3 seconds, "ON" show on the display with flashing hour
digits
* Press
* Repeat above steps to set Timer Off-time, Function (Tuner or TAPE) & Volume.
* Upon completion, all settings will cyclic once and then switch to current time with clock icon.
* By pressing BUZZER button, system switches to traditional alarm sound.
* REMARKS: WAKE UP BY TAPE (SHOULD BE PRESS THE PALY
BUTTON OF CASSETTE TAPE), OTHERWISE, TAPE WAKE UP CAN
NOT BE ACTIVATED.
* Note:1. ERROR reported if Off-time found equal or smaller than On-Time.
2. By pressing the TIMER SET button, the alarm is switched off.
3. For adjustment, press TIMER SET button for 3 seconds & input new selection.
SNOOZE
When system activates at wake timer, it can be temporarily switched off by pressing Snooze button. After 10
minutes, the system reminds you to wake up again. If you want to cancel the alarm set please refer to P.4
☆ Setting the SLEEP timer
This unit includes Sleep timer that automatically switch off after 10 to 90 minutes (to standby mode).
* Press SLEEP button which will start with 90 minutes.
* Every additional pressing reduces timer by 10 minutes.
* After a few seconds, Sleep time display will switch back to current time with sleep icon
Note: If current music source is less than Sleep time, ensure repeat function is activated.
flashes on the display.
to input desired hour & minutes, press TIMER button again to confirm.
3
to adjust hour
button to adjust the hour