What's In The Box; Abklemmen Der Batterie - Audio Vox VME 9415 Installationsanleitung

What's in the Box

• VME 9415 Head Unit
• External Microphone
• Power / Speaker Harness
• NAV104/Microphone Harness
• Hardware Bag
• Single DIN Sleeve
• Trim Ring
• Owner's Manual
• Installation Guide

ABkLEMMEN dEr BATTErIE

To prevent a short circuit, be sure to turn off the ignition and remove the negative (-) battery cable prior to
installation.
NoTE: If the VME 9415 is to be installed in a car equipped with an on-board drive or navigation computer,
do not disconnect the battery cable. If the cable is disconnected, the computer memory may be lost. Under
these conditions, use extra caution during installation to avoid causing a short circuit.
PrE-INSTALLATIoN
1. Put the 2 brackets between mounting sleeve
and the head-unit. Remove the sleeve.
2. Install the mounting sleeve:
a. Install mounting sleeve into the dashboard or
optional adapter.
Do not force the sleeve into the opening or
cause it to bend or bow.
b. Locate the series of bend-tabs along
the top, bottom and sides of the mounting
sleeve. With the sleeve fully inserted into the
dashboard opening, bend as many of the tabs
outward as
necessary so that the sleeve is firmly secured
to the dashboard.
c. Install the support strap to make the unit
more stable.
3. Place the radio in front of the dashboard
opening so the wiring can be brought through
the mounting sleeve.
CAUTION! Be careful not to damage the car
wiring.
WArNING! Never install this unit where operation and viewing could interfere with safe driving conditions.
Tools and Supplies
You will need these tools and supplies for installation:
• Torx type, flat-head and Philips screwdrivers
• Wire cutters and strippers
• Tools to remove existing radio (screw driver, socket
wrench set or other tools)
• Electrical tape
• Crimping tool
• Volt meter/test light
• Crimp connections
• 18 gauge wire for power connections
• 16 – 18 gauge speaker wire
2b
TAB
DASHBOARD
5
2c
2a
TAB
DASHBOARD