Bluetooth ® Pairing - Hama MyVoice 600 Bedienungsanleitung

Warning
Do not use the headset while it is charging.
• If the battery is fully charged, the status LED (3) will go out.
• Disconnect all cable and mains connections after use.
Note
If you have not used the item for a few month, it may take 15-30
minutes for the status LED (3) to red when charging.
5. Operation
Switching the headset on/off
• Turn On:
With the device off, press and hold the multi-function key (1) for
3 seconds until you hear a short tone. The LED indicator (3) lights
up blue and a voice says, 'Power On'.
• Turn Off:
With the device on, press and hold the multi-function key (1) for
5 seconds until you hear a long tone. The LED indicator (3) briefly
lights up red and a voice says, 'Power Off'.
The first time the device is turned on, pairing is automatically started
– see 5.1 Bluetooth
5.1. Bluetooth
Note – Pairing
• Make sure that your Bluetooth
and Bluetooth
• For more information, please refer to the operating instructions
of your terminal device.
• The headset and the terminal device should not be any further than
1 metre away from each other. The smaller the distance, the better.
• Ensure the headset is off.
• Device off: Press and hold the multifunction button (1) for
approximately 5 seconds until the status LED (3) begins to
alternate between red and blue and you hear a voice say, 'Pairing'.
The headset is searching for a Bluetooth
4
pairing.
®
pairing
®
is activated.
®
-capable terminal device is on
®
connection.
®