Digital Tv; Manual Search; Auto Search - Phonocar VM 206 Gebrauchsanweisungen

Digital TV

In the main menu of the system, under Digital TV, there are options such as auto TV search or broadcast
programs, program management, system set up, software update and software version information view etc.
In Main Menu, press CH+/- key to choose Digital TV option and then Press OK key to enter Digital TV menu.
Installation
There are three kinds of Installation mode as follow:
1. Area Search: searching programs by scan area.

2. Manual Search

3. Auto Search

You can enter into parameter "installation page" via input password digital (default password is "0000" ).
Area Search
Area search is a kind of intelligent and convenient mode of programs searching, which covers programs of all
frequency points of target countries and regions. At present, this system covers many targets countries and
regions including: Germany/ England/ Italy/ France/ Spain/ Holand/ Taiwan/China/Norwa y/ Sweden /Finland.
The default country (region) of system is Germany (you can select target countries you want under system
setting scan Area).
1. You can move the cursor to "area search" via press "CH+/-" key under "installation menu", then press
"enter" to enter into area searching page.
2. After entering into area search page, system will scan all programs under frequency points of current
countries or regions selected automatically.
3. During scanning, press "EXIT" key to stop and exit scanning.
4. If any program is detected and scanning process is finished, system will exit the scanning page and to play
them in window automatically.
Manual Search
If you understand much about digital TV and know the frequency of the program or if you want to scan the
program at any frequency required, you can select manual scanning, which can save your much time.
1. You can move the cursor via press "CH+/-" key under, then press "enter" to enter into area searching.
2. By means of 0-9-keys, choose channel and press OK.
3. If any program is detected and the scanning process is finished, system will exit the scanning page and
save the program, at the same time return to the "installation menu" and to play them automatically. As
shown in the figure below.
Auto Search
You can search the programs of any channel.
1. 1.You can move the cursor to "auto search" to enter into area searching.
2. Prior to auto scanning, you need to configure relevant parameters including: (1).Start Freq(KHz): the
default frequency is 474000KHz, you can input relevant digital to modify it. (2).End Freq(KHz): the default
28