Ayce AGS 10,8 LI 100-190 Original Bedienungsanleitung Seite 70

1. Workplace safety
a) Keep your work area clean and well illuminated. Untidy or unlit work areas
can result in accidents.
b) Do not operate the electric tool in an environment where there is a risk of
explosions and where there are inflammable liquids, gases or dust. Electric
tools produce sparks which could set the dust or vapours alight.
c) Keep the electric tool out of the reach of children and other persons. If there
is a distraction, you may lose control of the appliance.
2. Electrical safety
a) The connector plug from this electric tool must fit into the socket. The plug
should never be altered in any way. Never use adapter plugs together with
earthed electric tools. Unaltered plugs and correct sockets reduce the risk of
an electric shock.
b) Avoid bodily contact with earthed surfaces such as pipes, heating, ovens and
fridges. The risk of electric shock is increased if your body is earthed.
c) Keep the tool out of the rain and away from moisture. The ingress of water
into an electric tool increases the risk of an electric shock.
d) Do not use the cable to carry the electric tool, to hang it up or to pull it out of
the socket. Keep the cable away from heat, oil, sharp edges and moving parts
of the appliance. Damaged or entangled cables increase the risk of an electric
shock.
e) If you are working outdoors with an electric tool, only use extension cables
which are designed specifically for this purpose. Using specially designed
outdoor extension cables, the risk of electric shock is reduced.
f) If operation of the electric tool in a damp environment can not be avoided,
use a earth-leakage circuit-breaker. The earth-leakage circuit-breaker redu-
ces the risk of an electric shock.
3. Safety of persons
a) Be careful, watch what you are doing and use an electric tool sensibly. Do
not use the tool if you are tired or under the influence of drugs, alcohol or
medication. A moment of inattention when using the electric tool can result in
serious injuries.
b) Wear personal protection equipment and always wear safety goggles. Wea-
ring personal protection (such as dust masks, non-slip safety shoes, safety
helmet or ear protection, depending upon the type and use of the electric tool)
reduces the risk of injury.
c) Make sure that the appliance cannot start up accidentally. Ensure that the
electric tool is switched off before you connect it to the power supply and/or
insert the battery, or pick up or carry the tool. If your finger is on the switch
whilst carrying the electric tool or if you connect the appliance to the mains
Anl_AGS_10_8_Li.indd 70 Anl_AGS_10_8_Li.indd 70 02.12.15 13:32 02.12.15 13:32