Ayce R6212B Originalbetriebsanleitung Seite 66

Changing over from 1st gear to 2nd gear (Fig. 4)
Fig. 4
ON/OFF switch (Fig. 5)
Fig. 5
You can work at a higher or lower speed
depending on the position of the selector
switch. To avoid damaging the gear unit
you should only change over gears when
the tool has stopped.
Hold the tool firmly to control the twisting
of the tool.
To prolong the life of the tool never
overload it.
1. To start the tool, press the trigger
switch.
2. To stop the tool, release the trigger
switch.
3. If you press the lock on button while
the trigger switch is depressed, the switch
is kept in the operating position. This is
convenient when continuous operating for
extended periods of time is required.
4. To release the lock on button, press
and release the trigger switch.