Using The Adhesive Plates; Osd Menu Settings; Inserting The Micro Sd Card And Switching On The Camcorder; Basic Settings - Abus TVVR11001 Bedienungsanleitung

7.4 Using the adhesive plates

Attachment of an adhesive plate:
When you are attaching an adhesive plate, it is necessary to take the following into
account. The surface on which the straight or curved adhesive plate is to be attached
needs to be solid, even, and thoroughly cleaned. In order to bring about the optimal
adhesive effect, attach the plates to the required surface at room temperature. In order
to ensure optimal support for the accessory, you need to wait 24 hours after attachment
of the plate.

8. OSD menu settings

8.1 Inserting the micro SD card and switching on the camcorder

Insert your micro SD card in slot *15 intended for this purpose.
To switch on the camcorder, push POWER switch *20 from OFF to ON. After a short
time you hear a signal tone and the red status LED lights up.
Note:
 You can navigate using the *4*7*8*14 buttons. Confirm with button *6 and exit by
pressing button *5.

8.2 Basic settings

To make basic settings, use the Menu button *5. If you press this you will find all the
settings for the camcorder. Press the navigation button Right *14 to get to the camera
settings. Press the navigation button Right *14 once again to reach the setup settings.
There is another sign to indicate that you are in the setup settings in the top right corner
of the screen.
Example for setting the time and date:
 To set this correctly, press the navigation button Down *8 until you see the
Date/Time marked in blue. Press button *6 to confirm. Use the navigation buttons
*4*7*8*14 and button *6 to confirm for setting the time and date. Press menu button
*5 twice to exit the menu.
Please note that these adhesive plates can only be attached once.
These 3M adhesive plates adhere very tightly and will damage
sensitive surfaces (such as automotive paint) upon removal.
28
English