Abus TVVR11001 Bedienungsanleitung Seite 21

7. Location
Setup the device only in dry and dust-protected rooms. Protect the device from any kind
of liquids entering. Do not place the device near a radiator or heat register. Setup the
device only in areas with the advised operating temperatures of -10° ~ 60°C.
Warnings
Follow all safety and operating advises before starting-up the device!
1. Follow these directions in order to avoid damage of the power cord or plug:
 Do not modify or process the power cord or plug arbitrarily.
 Do not bend or twist the power cord.
 Make sure to disconnect the power cord holding the plug.
 Keep heating appliances as far as possible from the power cord in order to
prevent the cover vinyl from melting.
2. Follow these directions. Failure to follow any of them may cause electrical shock:
 Do not open the main body.
Disconnect the product from the mains before you start.
 Do not insert metal or inflammable objects inside the product.
 In order to avoid any damage during lighting use a surge protection.
3. Do not use the product when it is out of order. If you continue to use the product when
defective, serious damage can be caused to it. Make sure to contact your local product
distributor if the product is out of order.
During the installation into an existing video surveillance system make sure that
all devices are disconnected from the low and supply voltage circuit.
If in doubt allow a professional electrician to mount, install and wire-up your
device. Improper electrical connection to the mains does not only represent at
threat to you but also to other persons.
Wire-up the entire system making sure that the mains and low voltage circuit
remain separated and cannot come into contact with each other in normal use or
due to any malfunctioning.
Unpacking
While you are unpacking the device please handle it with utmost care.
If you notice any damage of the original packaging, please check at first the
device.If the device shows damages, please contact your local dealer.
21
English