After Your Training Session; Cleaning & Storage; Emc - TensCare perfect BEAUTY Bedienungsanleitung

help you identify the best programme
to suit you.
4) Identify the correct pads positioning
for the selected area and apply the
electrode pads as described in
section 8.3.
5) Once the electrode
correctly positioned,
intensity as described in 7.3. with the
buttons CH1-, CH1+, CH2- and
CH2+. The LCD display shows the
strength of intensity used for each
channel.
Note: If the sensation becomes
uncomfortable,
intensity.
11.5. AFTER YOUR TRAINING
SESSION
When the timer reaches zero, your
session is complete and the unit turns
off.
1) Check that the control unit is OFF. If
it is not, hold down the OFF button to
switch off then remove the electrode
pads from your skin by holding the
pad itself and gently pulling. Be
careful not to pull the wires as this
may damage them.
2) Replace the electrode pads to their
protective plastic shield and return
them to the re-sealable plastic bag.
Note: When
electrode pads, DO NOT PULL
ON LEAD WIRES.
pads are
adjust the
reduce the
removing the
27
12. CLEANING &
STORAGE
Clean the case and lead wires at least
once a week by wiping with a damp
cloth and a solution of mild soap and
water. Wipe dry.
• Do not immerse your perfect
BEAUTY unit in water.
• Do not use any other cleaning
solution than soap and water.
Storage life
• Storage life of an unopened pack of
self-adhesive electrode pads is 2
years. This may be affected by very
high temperatures or very low
humidity.
• The unit has no fixed shelf life.

13. EMC

Wireless communications equipment
such as wireless
devices, mobile phones,
telephones and their base stations,
walkie-talkies can affect this equipment
and should be kept at least a distance d
= 3,3 m away from the equipment.
(Note. As indicated in Table 6 of IEC
60601-1-2:2007 for ME EQUIPMENT,
a typical cell phone with a maximum
output power of 2 W yields d = 3,3 m at
an IMMUNITY LEVEL of 3 V/m).
Note: For hospital use, full EMC
advice tables are available on
request.
home network
cordless