Before Initial Use; Changing The Remote Control Battery; Use - EASYmaxx H03 Gebrauchsanleitung

Before initial use

Before using the device, remove all packaging materials
and any labels that may be on the device and are used for
protection during transportation or for advertising. Never
remove the rating plate and any possible warnings!

Changing the remote control battery

3. Slide the battery compartment all the way back into the
remote control. It must audibly and noticeably lock into
place.

Use

PLEASE NOTE!
■ The heater should only be used in wall sockets in a vertical
position, and not horizontally (lying).
■ The device is equipped with protection against overheating;
the device switches off if it gets too hot. In this case you
turn the ON / OFF switch to the 0 position. You then allow
the device to cool down and remove the plug from the
socket. It will be ready for use again after approx. 10 – 15
minutes.
1. The battery compartment is lo-
pull
2. Remove the empty battery and
push
25
cated on the narrow side of the
remote control. Remove it as
shown.
insert a new battery (3 V, type
CR2025). The positive terminal
must point upwards.
EN