AEG FSK52600P Benutzerinformation Seite 10

10 www.aeg.com
German de-
grees (°dH)
<4
1) Factory setting.
2) Do not use salt at this level.
Whether you use a standard detergent
or multi-tabs (with or without salt), set
the proper water hardness level to
keep the salt refill indicator active.
Multi-tabs containing salt
are not effective enough to
soften hard water.
How to set the water softener
level
Make sure the appliance is in user mode.
1. Press
• The indicators
are off.
• The indicator
• The display shows the current
setting: e.g.
2. Press
setting.
3. Press on/off to confirm the setting.
6.3 The rinse aid empty
notification
The rinse aid helps to dry the dishes
without streaks and stains.
The rinse aid is automatically released
during the hot rinse phase.
When rinse aid chamber is empty, the
rinse aid indicator is turned on notifying
to refill rinse aid. If the drying results are
satisfactory while using multi-tablets
only, it is possible to deactivate the
notification for refilling rinse aid.
However, for best drying performance,
always use rinse aid.
If standard detergent or multi-tablets
without rinse aid are used, activate the
notification to keep the rinse aid refill
indicator active.
French degrees
(°fH)
<7
.
, ,
still flashes.
= level 5.
repeatedly to change the
mmol/l Clarke de-
<0.7
How to deactivate the rinse
aid empty notification
Make sure the appliance is in user mode.
1. Press
• The indicators
are off.
• The indicator
• The display shows the current
setting:
notification is activated (factory
setting).
2. Press
and
= the rinse aid empty notification is
deactivated.
3. Press on/off to confirm the setting.
6.4 The rinse aid dispenser
The rinse aid helps to dry the dishes
without streaks and stains.
The rinse aid is automatically released
during the hot rinse phase.
It is possible to set the released quantity
of rinse aid between level 1 (minimum
quantity) and level 6 (maximum quantity).
Level 0 deactivates the rinse aid
dispenser and no rinse aid is released.
Factory setting: level 4.
How to set the rinse aid level
Make sure the appliance is in user mode.
1. Press
• The indicators
are off.
• The indicator
flash.
• The display shows the current
setting: e.g.
Water softener lev-
grees el
< 5
1
.
, ,
still flashes.
= the rinse aid empty
to change the setting.
.
, ,
continues to
= level 4.
2)
and
and