Safety Instructions - CONDTROL IR-CAM 2 Bedienungsanleitung

Thermal imager
display/delete images
select option «saved images» in menu, press
the display (see picture below).
press or to select image. to view image press
the product will enter image display mode (see picture below).
Flip the images by pressing
suggest to delete currently displayed image.
to cancel remove press . to return to menu press
16
IR-CAM 2 CONDTROL
User manual
. A list of saved images will appear on
,
. After you press the product will
to delete image press ,
.
Thermal imager

SaFETy INSTruCTIONS

attention! this product is an accurate optical and electronic device and requires delicate
handling. unintended use of the product can be dangerous for human's health! the user
manual should be read carefully before you use the product for the first time. if the product is
given to somebody for temporary use, be sure to enclose user manual to it.
- do not misuse the product.
- do not remove warning signs and protect them from abrasion, because they contain
information about safe operation of the product.
- it is prohibited to disassemble or repair the product yourself. intrust product repair to
qualified personnel and use original spare parts only.
- do not use the product in explosive environment, close to flammable materials.
the actual temperature of the object may differ from the results of measurement. investigated
surface can be potentially dangerous! Measured objects or environment can also pose risks.
the following recommendations will extend the life of the product:
- it is forbidden to point the product at the sun or other sources of intense emission (objects
with temperature exceeding +300 °С). It can lead to serious damage of detector.
- protect the product from bumps, drops, excessive vibration; do not allow moisture,
construction dust, foreign objects inside the product;
- in case of moisture getting inside the product, first remove batteries and then apply to
service center;
- do not store or use the product in high humidity environment for a long period of time;
- to clean the product use a soft cloth wet cloth.
non-compliance of the below mentioned instructions can cause electrolyte leakage and
product damage:
- remove batteries from the product, if it is not used for a long period of time;
- do not use batteries of different type or with different charge levels;
- do not leave discharged batteries inside the product;
- do not heat the batteries to avoid the risk of explosion and electrolyte leakage. in case of
liquid contact with skin, wash it immediately with soap and water. in case of contact with
eyes, flush with clean water during 10 minutes and consult the doctor.
IR-CAM 2 CONDTROL
User manual
17