Velleman CAMCOLD7 Bedienungsanleitung Seite 4

Overview
5.
Configuration
6.
•
Before installing the mini pan/tilt dome, it must be configured though setting the
dipswitches that are located inside the dome. To reach the dipswitches, open the dome by
rotating the transparent cover (2) clockwise and lifting it.
•
Be very careful not to touch any other part inside the housing while setting the switches,
as damage might occur.
•
SW1~SW4 are used to set the ID of the device, allowing for a system with up to 15
unique devices. However, when using the IR remote control device, only the 9 first
(lowest) IDs can be controlled.
•
SW5 and SW6 set the BAUD rate, SW7 the used protocol and SW8 sets the type of alarm
contact to normally open (N.O.) or normally closed (N.C.).
ID SW 1
0 OFF
1 ON
2 OFF
3 ON
4 OFF
5 ON
6 OFF
7 ON
8 OFF
9 ON
10 OFF
11 ON
12 OFF
13 ON
14 OFF
15 ON
•
Close the dome by placing the transparent cover (2) back and turning it counter
clockwise. Secure the transparent cover by mounting a small screw in the hole in the
housing.
00 (17/09/2008)
CAMCOLD7
SW 2 SW 3 SW 4
OFF OFF
OFF OFF
ON OFF
ON OFF
OFF ON
OFF ON
ON ON
ON ON
OFF OFF
OFF OFF
ON OFF
ON OFF
OFF ON
OFF ON
ON ON
ON ON
Dome
1. Camera
2. Transparent cover
3. Non-transparent housing
4. Mounting plate
5. Input/output cable
5a. video output (BNC)
5b. power input
5c. communication
IR receiver
6. DC power input
7. RS-485 D+
8. RS-485 D-
9. Ground
OFF SW 5
OFF ON
OFF OFF
OFF ON
OFF
OFF
OFF
OFF
ON
ON
ON
ON
ON
ON
ON
ON
4
SW 6 BAUD rate
ON 2400
ON 4800
OFF 9600
SW 7 Protocol
ON Native
OFF PELCO
SW 8 Alarm type
ON N.O.
OFF N.C.